Reproduction forbidden without Fibocom Wireless Inc. written authorization - All rights reserved.
FIBOCOM MC610 Series Hardware Guide
43/70
Figure 3-16 Reference design diagram of network indicator for MC610 series modules
3.8 Low Power Mode
3.8.1 Sleep Mode
3.8.1.1 Only UART Port Data Communication Between AP and Module
The sleep mode can be activated by module by the following ways:
1. The ATS24 command makes the module to sleep, and the wake-up keeping time depends on </value>
in the command
ATS24 = [<value>].
Send the AT command:
ATS24=2
. The module will enter the
Sleep mode in 2 s, and the setting will not be saved after the module is powered down.
2. Set the sleep mode through AT+GTSET="LPMMODE". x set and save the settings after power
failure.
x=1 --- level wakeup, WAKEUP_IN indicates that sleep is not allowed at low level;
x=2 --- level wakeup, WAKEUP_IN indicates that sleep is not allowed at high level;
