ELECTRONIC COMBINATION
BRINGING INTO SERVICE: INSTALLING THE BATTERIES
-
Turn the keypad anticlockwise
.
- Separate the keypad housing from the keypad.
-
Insert and connect battery (use a 9 volts alkaline battery: 6LR61 type).
-
The lock will beep twice to confirm the connection.
-
Clip on the keypad housing carefully not to trap the electric cable, then turn the
keypad clockwise to close it.
-
An alarm sound is emitted each time the lock is woken up (the lock wakes up by
pressing a key after at least 10 seconds of inactivity) until a complete opening
session has been carried out.
- Check the opening and closing of the combination once or twice before
closing the door, then change the opening code.
TIP:
Each time you change the combination, it is advisable to check it 2 or 3 Times
(with the door open).
OPENING THE SAFE
- Press “Enter” to wake the electronic combination out of standby. The green indicator
blinks once rapidly.
- Enter your opening code (“0.0.0.0.0.0”) the first time you open the lock). Each time
you press a key, the green indicator blinks once.
- Validate your entry by pressing “Enter”. If the entered code is correct, the green
indicator blinks throughout the unlocking process, then remains on for 5 seconds.
- Turn the handle clockwise to open the door.
CLOSING THE SAFE
- Close the door to the safe.
- Turn the handle anticlockwise.
- When the handle reaches the stop to the left, the electronic combination
automatically locks.
IMPORTANT
: Do not attempt to turn the handle during the locking
or unlocking processes of the electronic combination.
