１２
Error
Indicator Status
Description
ERROR
Code
(HEX)
Paper out
Indicator blinks
Print head
uplift
Buzzer rings
Put down print head
Print head
overheat
Buzzer rings and
indicator blinks
Recovers automatically
when the print head
cools.
Auto cutter
Position Error
Buzzer rings and
indicator blinks
Impossible to recover,
check if there is paper
jam.
POWER light is the power indicator, red ERROR light is status indicator, it
is dark when the printer works normally, while it flashes when reporting an
abnormal emergency, as the following form shows:
When any error shown above occurs, different status and data will be
returned according to different printing commands.
2.5 Self-test
The self-test will check the condition of printer, if the printer prints out the
self-test receipt correctly, it means the printer works normally. Otherwise it
needs to repair.
The self-test will print out the firmware version, interface setting and 128
ANK characters.
Hold down
【
FEED
】
button and turn on the power, then release the button,
self-test begins automatically at this moment.
2.6 Printer Setting
User can use the Setting Tool to set the serial interface, printing density etc.
parameters, also can use the following commands to set:
1B 09 Set to start
1B 10 n1 n2
1B 15 Set to stop
The data of n1, n2 will be returned by serial interface.
n1 is used to set the baud rate and data format, the details for setting please
refer to the following:
n1 indicates:
Serial Interface:
