GAS SPILLAGE SENSING KIT
Model:
GSK-3
Installation of a spillage SAFETY Switch is recommended for
LP and Natural gas fired systems with draft hoods, draft
diverter, and gas barometric draft controls. This device is
installed to detect flue gas spillage caused by a blocked flue
system and/or inadequate draft. This device MUST be installed
by a qualified installer in accordance with the manufacturer's
installation instructions. Wiring MUST be in accordance with the
National Electrical Code and applicable local codes.
Before and after adding this safety control on existing
appliances, an installation inspection in accordance with the
National Fuel Gas Code 54, Z223.1 Appendix H should be
performed and a combustion analysis is recommended to
determine the operating condition of the appliance.
CAUTION:
Disconnect Electrical Power When Wiring Spillage
Switch
