Field Controls CLEARWAVE CW-HD-1, Manual

Page 4

INSTALLATION 

W

HERE TO INSTALL THE 

C

LEAR

W

AVE

™ 

1.  For domestic water applications, locate where the main water supply pipe enters the home or building.  For 

light commercial applications such as dishwashers, ice makers, boilers, water heaters etc., attach the 
ClearWave™ unit to the water supply line to that particular appliance. 

2.  Find a suitable location to install the ClearWave™ on the water supply pipe before the piping branches off 

to supply water throughout the home. 

H

OW TO INSTALL THE 

C

LEAR

W

AVE

™ 

1.  One set of mounting brackets are provided, for mounting the ClearWave™ onto 1/2” to 1-1/2” water pipes 

or wall mounted near the selected pipe area.  Mount the mounting brackets to the base of the ClearWave™ 
by using the screws provided.  Mount the ClearWave™ onto the pipe with wire ties or to the wall with 
appropriate fasteners.  (see Figure 1)  For pipe mounting, the wall mount tabs should be removed from the 
mounting brackets.  (see Figure 2) 

2.  Plug the antenna into each end of the housing.  If longer wires are needed, up to 50 feet of 12Ga stranded 

wire can be added to the antenna wires with an insulated butt end wire connector or they can be replaced 
with 65 feet of 12Ga stranded wire. 

Figure 1 

Figure 2