WARNING: never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness.
Never operate the UV-Aire™ AirPurifying System out of the plenum. Avoid touching the glass portion of the lamp with your hands.
WARNING: Never expose eyes or skin to UVC light from any source.
•
Looking directly at the UVC light may cause permanent eye damage or blindness.
•
Never operate the UV-Aire™ Air Purifying System out of the plenum.
•
Designed for a closed duct system. Do not mount near a supply or a return air opening.
•
All duct openings in direct line of site of the UV light must be sealed with aluminum tape or equivalent
sealing methods.
WARNING: UV light will break down plastic materials not rated for UV exposure:
(Examples: wire insulation, flex duct, drain pans and humidifiers)
• The unit must be mounted at least 30" from the above stated type of materials.
•
If it is necessary to mount the unit in direct line of sight of these types of materials, they must be shielded
with aluminum foil, aluminum foil tape, or sheet metal.
WARNING: DO NOT mount this unit outdoors.
• This product is designed for indoor installation only (i.e. attics, crawl spaces, basements, etc.).
This product is not sold as a medical device and is not for the purpose of diagnosis of any disease or condition
nor for use in the mitigation, treatment, or prevention of any disease or condition.
INDICATION FOR USE
There are different size units available, depending on the tonnage of your HVAC system. See chart below for
determining the needs of your home.
The FlexMount™ UV-Aire™ system is provided with a unique patent-pending, magnetically-attached Mounting
Bracket Assembly. The mounting bracket assembly may be rotated and/or extended relative to the mounting
surface, to provide maximum flexibility in mounting positions and configurations.
A reflective aluminum shield is included which may optionally be used to shield wiring, ductwork and parts
which could be damaged by UVC exposure, and/or concentrate the UVC rays in a particular area such as
the A-coil. The shield may be attached to the lamp bracket in four different positions, so that the bracket
assembly may be positioned in such a way as to create minimal obstruction to air flow, and provide maximum
flexibility in positioning of the lamp relative to the bracket and mounting surface.
The part of the lamp bracket to which the lamp is attached may be separated from the mounting bracket
assembly, and used for mounting the lamp through a delta plate covering the end of the A-coil, or for
mounting the lamp inside of a plenum or air duct.
GENERAL INFORMATION
MODEL
VOLTS
AMPS
HZ
WATTS
(LAMP)
MAX AIR TEMP °F
UVC INTENSITY
AT 1 METER
RECOMMENDED
HVAC TONNAGE
UV-13FM
24
1.5
50/60
24
190°
65 µW/cm2
1.5-3
UV-17FM
24
1.9
50/60
36
190°
110 µW/cm2
1.5-5
