Field of View GeoSnap PPK Manual 6
INSTALLATION PROCEDURE
The following procedure covers installation of the GeoSnap PPK with the M600 Pro mounting kit.
Note: The PWM/GPIO input cable is included in this kit for use with the A3 flight controller. If you do not want to
use the A3 Flight controller to send trigger commands to the camera you may Skip steps 1, 2, 3, and 7. If you would
like to use this functionality now or in the future we recommend performing steps 1, 2, 3, and 7 to enable PWM
trigger control.
1.
Remove the top cover of the M600 Pro by removing the 6 screws circled below.
2.
Plug in the PWM/GPIO input cable into the F8 port on the A3 flight controller as shown.