Fieldmann FDAH 2002, User Manual

OPERATING INSTRUCTIONS

1. Raise load high enough to allow clearance for the jack stands to be removed, then

carefully remove jack stands.

2. Remove support stands.
3. Grasp the handle firmly with both hands. Securely hold on to the jack handle so your

hands do not slip and ensure the release valve does not rapidly lower.

4. Carefully open the Release Valve by slowly turning the handle counter-clockwise. (Do

not allow bystanders around the jack or under the load when lowering the jack. 

LOWERING THE JACK

7. Before raising the vehicle double check and verify the saddle is centered and

also has full contact with the lifting point.

8. Pump handle to lift until saddle contacts load. Continue to pump the jack

handle to lift the vehicle to the desired height. After lifting, support the load with

appropriately rated vehicle support stands before working on the vehicle.

CAUTION: 

NEVER WIRE, CLAMP OR OTHERWISE DISABLE THE LIFT CONTROL VALVE 

TO FUCTION BY ANY MEANS OTHER THAN BY USING THE OPERATOR'S HAND. USE THE 

HANDLE PROVIDED WITH THIS PRODUCT OR AN AUTHORIZED REPLACEMENT 

HANDLE TO ENSURE PROPER RELEASE VALVE OPERATION. DO NOT USE EXTENSIONS 

ON THE OPERATING HANDLE.

HYDRAULIC FLOOR JACK

1

4 

EN

Assembly