OPERATING INSTRUCTIONS
BELT SANDER
Service
Do not change parts of the tool, do not perform repairs on your own and do not interfere with
the tool’s construction in any way. Leave tool repairs to qualified persons.
Each repair or product modification performed without our company’s permission is
inadmissible (it can cause injury or harm to the user).
Always leave tools to be repaired in a certified service centre. Use only original or
recommended spare parts. This will ensure your and your tool’s safety.
4
. SPECIAL SAFETY INSTRUCTIONS
Safety warning for works such as grinding, surfacing, wire brushing,
polishing or abrasive cutting
WARNING!
Before use, please read these safety instructions and keep them
in a safe place.
Upon failure to follow the instructions specified in this manual, there is a risk of injury.
Angle grinder conforms to applicable technical regulations and standards.
These electro-mechanical tools are intended for use as grinder. It is necessary to read
all safety warnings, instructions, illustrations and specifications for the electro-
mechanical tools. Non-compliance with the below mentioned instructions can lead to
injury by electrical current, fire and/or serious injury.
Accessories not specifically designed and recommended by the tool's manufacturer
may not be used. The mere fact, that an accessory can be connected to your tool does
not guarantee its safe operation.
The nominal speed of the accessory has to be at least equal the maximal speed marked
on the tool. Accessories, operating at higher speeds than its nominal speed, can break
and fall apart.
The outer diameter and thickness of the accessory has to be within the limits of the
nominal range for particular electromechanical tools. The accessories of incorrect size
cannot be sufficiently guarded or controlled.
It is prohibited to use damaged accessories.
Personal protective equipment has to be used. According to condition a face shield or
safety goggles have to be used. Use dust mask, hearing protection, gloves and work apron,
capable of arresting small fragments of the abrasive material or work piece, as
appropriate. Eye protection has to be capable of arresting flying fragments, generated
during various work activities. Dust mask or respirator has to be able of filtering particles,
generated during a particular activity. Long-term exposure to high-intensity noise can cause
loss of hearing.
EN
10
General safety instructions| Specific safety instructions
Summary of Contents for FDBP 200901-E
Page 1: ...FDBP 200901 E...
Page 2: ...3 A...
