Fieldmann FDU 2120-E, User Manual

EN

ASH VACUUM CLEANER

USER’S MANUAL

13

Safety measure/vacuum cleaner assembly  

5. SAFETY PRECAUTIONS 

Vacuuming water

  Under no circumstances should you use a carpet nozzle with a metal underside for wet vacuuming - risk of 

corrosion!

  The vacuum cleaner is equipped with a float system, and if the container is filled to the maximum liquid level 

during water vacuuming, this system will close the air flow. The engine noise will increase significantly and 
you will hear a noticeably different sound. Further vacuuming is only possible after the container has been 
emptied.

  CAUTION: 

If while vacuuming water the vacuum cleaner tips over, it is necessary to have the vacuum 

cleaner motor inspected by a service before further use.

  CAUTION: 

Never use this vacuum cleaner as a full substitution for a pump, i.e. pumping water from tanks, 

baths, aquariums, etc. The seal on the hose could be damage by the high pressure.

  CAUTION: 

After finishing vacuuming of water it is necessary to allow the vacuum cleaner to run for 

another 30 seconds, so that the remaining water is sucked out of the hose and tube.

Turning your vacuum cleaner on and off

  To switch your machine on or off, press the I/0 button on the vacuum cleaner body.

Adjusting the suction strength

  Suction can be controlled within a small range by a sliding flap on the hose handle.

6. VACUUM CLEANER ASSEMBLY 

  Before assembling or disassembling individual parts of accessories, always unplug the power cord first.
  Have all the accessory parts ready.
  Insert spout on the hose handle.
  Assemble the flexible hose as shown on figure and insert its connection end in the air intake hole on the 

vacuum cleaner. Press inside so that a click is heard when the hose reaches the correct position.

  Install the filter.
  Attach the wheels.