FZD 4010-E
18
EN
How to handle the product?
What to do when replacing knives?
(Fig. 8)
Switch-off the shredder and disconnect from the mains.
Take-off the upper part of the feed hopper assembly by unscrewing the adjustment knob of
the pressure plate cover.
The knives are double-sided. If the blade is worn-out, it can be upturned and used by the other
side.
You should wear gloves while handling the knives in order to replace them.
Arrest the shredder roller with the help of a hexagonal wrench (c). Unscrew both inner
hexagonal nuts (b), whereas pay close attention to the knife cutting angle.
Take-off the knife and turn by 180 degrees (a); position the blade on the roller so that the
bottom side points downwards.
Follow the same procedure when replacing the other knife.
If both blades of the knife are worn-out, they must be both replaced at the same time.
They can be re-sharpened. (Sharpening must be carried out by a skilled specialist.) We do not
recommend this solution with regard to the fact that the absolute balance of the knives on the
roller is highly important for the proper functionality of the machine. The slightest unbalance
may result in damage of the machine or even in injury of the operating person.
How to maintain the product?
WARNING!
Make sure the machine is disconnected from the mains while performing
maintenance and cleaning.
Before a service inspection, storage or replacement of some part, switch-off the engine and
disconnect the equipment from the mains.
If the extension cable is used, it must not be lighter than the power supply cable belonging to
the equipment.
Check the power supply cable and in case of need the used extension cable for signs of wear
regularly. In the case of damage do not use the equipment.
While carrying out any service maintenance of the shredding mechanism, do not forget that
the mechanism can be switched-on even manually despite of the interlock switch stop.
Never deactivate the interlock switch.
Remove dirtiness from the equipment with the help of a brush.
Always clean the machine after each use. Use soap and a wet rag for cleaning the plastic
parts. Do not use aggressive substances and solvents.
Never clean the shredder by water stream. Keep the equipment protected against water.
Use the shredder only with recommended accessories.
Summary of Contents for FZD 4010-E
Page 1: ...FZD 4010 E...
Page 3: ...3 4 2 3 5 10 11 8 a b c d...
