EN
18
FZS 3002-B
Maintenance and storage
10. MAINTENANCE AND STORAGE
Maintaining the machine
Before every use:
– Check that all nuts and bolts are tightened.
– Check that no fuel is leaking from the fuel tank.
– Lubricate the gearbox with grease.
After every 20 hours of operation (For this purpose we recommend you contact an authorised service
centre):
– Clean the air fi lter.
– Clean the fuel fi lter.
After every 50 hours of operation (For this purpose we recommend you contact an authorised service
centre):
– Clean the spark plug and adjust the gap between the electrodes to a distance of 0.6–0.7 mm.
– Clean out deposits from the exhaust and muffl er.
– Disconnect the shaft and lubricate with quality lubricant.
Check the installation after performing maintenance and check that all nuts and bolts are pulled tight.
Service
In the event that after purchasing the product you fi nd any kind of defect, contact the service department.
When using the product, follow the instructions contained in the included user’s manual.
A complaint will not be accepted if you modifi ed the product or if you did not follow the instructions in the
user’s manual.
Warranty does not cover:
Normal wear and tear of operating parts of the machine as a result of its use
Servicing tasks related to standard maintenance of the machine (e.g. cleaning, lubrication, tuning, etc.)
Defects caused by external effects (e.g. climatic conditions, dustiness, inappropriate use, etc.)
Mechanical damage resulting from the machine being dropped, impact, etc.
Damages resulting from unprofessional handling, overloading, use of incorrect parts, inappropriate tools,
etc. On returned products that were not properly protected against mechanical damage during transport, the
risk of potential damage is borne exclusively by the owner.
Storage
ATTENTION!
If you will not be using the machine for an extended period of time, store it according to the
following instructions. This will extend the lifetime of the machine.
Fully drain fuel from the fuel tank and the carburettor. Close the choke and pull on the cord 3 to 5 times.
Screw out the spark plug and pour a small amount of motor oil into the socket. Gently pull the pull cord
2 to 3 times.
Use a clean cloth to clean the exterior surfaces. Store the machine in a clean dry location.
