EN
PETROL BRUSH CUTTER
USER'S MANUAL
11
5. ASSEMBLY
Push the l part of the rod (1) right down until the latch
(2) slots into the hole (3) in the rod. This is easier to
do if you rotate the bottom of the rod (6) slightly in
both directions. The latch (2) is in place when it is
completely lodged in the hole. - Lastly, Press the latch
cover(5) and then tighten the knob (4) securely.
INSTALLING HANDLE (A)
Install handle in bracket. Position handle in
a comfortable operating position and tighten four
M6×30 screws.
INSTALLING HANDLE (B)
Install handle and lower cap on the rubber cover, and
tighten four M5×32 screws.
INSTALLING HANDLE
Install handle in bracket. Position handle in
a comfortable operating position and tighten U Handle
Screw Assy.
ADJUST U Handle
1. Rotate the U Handle Screw Assy counterclockwise
to adjust the U Handle
2. Rotate the U Handle Screw Assy counterclockwise
then Drag U Handle Lock Bar to Rotate the
U Handle.
WARNING CAUTION
Do not attempt to disassemble the two special
screws. The two clamps position has been adjusted
at a suitable place,do not attempt to remove or move
them. Otherwise,it can result in serious personal injury.
Assembly
Fig. 1
Fig. 2
1
2
Fig. 3
M5×32
SCREWS
HANDLE
CLAMP
LOWER CAP
SPECIAL
SCREWS
M6×30
SCREWS
M6×30
SCREWS
CAP, UPPER
CAP, UPPER
BRACKET
U-HANDLE
U-HANDLE
BRACKET
U Handle Screw Assy
CAP, UPPER
BRACKET
U-HANDLE
U Handle
Screw Assy
U Handle
Screw Assy
U Handle Lock Bar
U Handle Lock Bar
