EN
PETROL BRUSH CUTTER
USER'S MANUAL
17
CUTTING WITH A NYLON HEAD
Line head rotates in a counter CLOCKWISE direction.
The CUT-OFF KNIFE will be on the right side of the
debris shield.
WARNING DANGER
The proper debris shield must be in place on the unit
when nylon cutting line is used. The cutting line can
fl ap around if too much line is exposed. Always use
the plastic debris shield with cut-off knife when using
nylon cutting heads.
For nearly all cutting, it is good to tilt the line head
so that contact is made on the part of the line circle
where the line is moving away from you and the debris
shield. (See appropraite picture) Thisresults in the
debris being thrown away from you.
WARNING DANGER
Tilting the head to the wrong side will shoot the debris
TOWARDS you.If the line head is held fl at to the ground
so that cutting occurs on the whole line circle, debris
will be THROWN at you, drag will slow the engine
down, and you will use up a lot of lines.
WARNING DANGER
Use only quality nylon monofi lament line of the
diameter 2.5mm. Never use wire or wire-reinforced
line in place of nylon trimer line. Load your nylon line
cutting head only with nylon trimmer line of the proper
diameter.
WARNING DANGER
Use extreme caution when operating over bare spots
and gravel, because the line can throw small rock
particles at high speeds. Debris shields on the unit
cannot stop objects which bounce or ricochet off hard
surfaces.
Safety working with brush cutter
Fig. 12
Fig. 13
CUT-OFF KNIFE ON LEFT SIDE
COUNTER CLOCK WISE ROTATION
DEBRIS
CUT ON THIS
SIDE
