EN
PETROL BRUSH CUTTER
USER'S MANUAL
9
4. DESCRIPTION OF THE MACHINE
17
1
2
3
4
5
6
9
7
8
10
11
12
13
16
14
15
1. BLADE - Circular blade for grass,weed or brush cutting applications. Harness, plastic shield and U-Handles
required for blade operation.
2. DRIVE SHAFT ASSEMBLY - Contains a specially designed inner fl exible drive shaft.
3. THROTTLE TRIGGER - Spring loaded to return to idle when released. When accelerating, press trigger
gradually for best operating technique. Do not hold trigger while starting.
4. IGNITION SWITCH - Move switch to position “|” to start, to position “O” to stop.
5. THROTTLE LOCKOUT - Before acceleration, compress it please.
6. U-HANDLE - this handle can be adjusted at your convenience for comfort.
7. HARNESS ASS’Y - an attachment which hang the machine on the operator and adjustable in length.
8. AIR CLEANER COVER - Contains replaceable felt element.
9. FUEL TANK LID.
10. FUEL TANK - Contains fuel and fuel fi lter.
11. PRIMING BULB - Presing the priming bulb pumps (7 to 10 times before starting), will remove all air and stale
fuel from fuel system and bring fresh fuel to the carburetor.
12. CHOKE - the choke control is located on the side of the fi lter cover.
COLD STARTS Pull lever up to close choke for cold starts. push lever down for RUN position.
13. DEBRIS SHIELD - Mounted just above the cutting attachment. Helps protect operator by defl ecting debris
produced during the trimming operation. Do not operate unit without shield.
Description of the machine
