11
12
13
14
15
Certifications
and Module IDs
FCC&IC Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
: To assure continued compliance, any changes or
modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
(Example - use only shielded interface cables when connecting to
computer or peripheral devices).
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device complies with Industry Canada licence-exempt RSS-
247
standard. Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any
interference, including interference that may cause unde-sired operation of
the device.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
IC Radiation Exposure Statement:
This equipment complies with IC
RSS-102 radiation exposure limit set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance
0.5 cm between the radiator and your body.
Cet équipement est conforme aux CNR-102 d'Industrie Canada. Cet
équipement doit êtreinstallé et utilisé avec une distance minimale de 0.5
centimètres entre le radiateur et votrecorps. Cet émetteur ne doit pas être
co-localisées ou opérant en conjonction avec autreantenne ou émetteur.
Les antennes utilisées pour cet émetteur doivent être installés etfournir
une distance de séparation d'au moins 0.5 centimètre de toute personne et
doit pas être co-située ni fonctionner en conjonction avec une autre
antenne ou émetteur.
Fieldpiece Instruments 1636 West Collins Avenue, Orange, CA 92867
EN 300 328
RSR47D: 2ALHR010
SR47: 2ALHR011
IC: Industry Canada
RSR47D: 22518-BT010
SR47:
22518-BT011
Regulatory Compliance Mark
Waste Electrical and
Electronic Equipment
Restriction of Hazardous
Substances Compliant
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and
operated with a minimum distance of 0.5 centimeters between the radiator
and your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter. The antennas used for
this transmitter must be installed to provide a separation distance of at least
0.5 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
