FS-8700-48 Fike Cheetah Manual
Page 29 of 36
FieldServer Technologies
1991 Tarob Court Milpitas, California 95035 USA
Web
: www.fieldserver.com
Tel
: (408) 262 2299
Fax
: (408) 262 2269
Toll Free
: (888) 509 1970
: support@fieldserver.com
Appendix D.
Reference
Appendix D.1.
Driver Scope
This driver has implemented cheetah command #6.0. These messages are produced by a Cheetah device
controller and are consumed by this driver. The driver has no control on the frequency of the messages and thus
cannot guarantee fresh data. In addition the protocol has no method for acknowledging messages so that in the
event of this driver having to discard a corrupt message, the message producer does not know and will not re-
send.
Appendix D.2.
Panel Firmware Versions
The driver supports older versions of panel firmware which transmit a shorter version of the Panel Status
command. This shorter version contains only panel data whereas the newer version contains panel, zone & device
data.
Appendix D.3.
Storing Panel Data
Panel data is stored in consecutive locations as described in the map below. For additional explanations on the
meaning of each data element contact FIKE directly.
Array Location Data Category
Data stored at this location
0
Active Counter (0..65535)
Active events in normal state
1
Active events in Process state
2
Active events in Trouble state
3
Active events in Supervisory state
4
Active events in Drill state
5
Active events in ? state
6
Active events in ? state
7
Active events in ? state
8
Active events in Abort state
9
Active events in Pre-Alarm1 state
10
Active events in Pre-Alarm2 state
11
Active events in Alarm state
12
Active events in Pre-Discharge state
13
Active events in Release state
14
Active events in Zone Discharge state
15
Active events in Water Mist state
16
Board Status Indicators (0 or 1) Alarm silence active 1=yes
17
Supervisory Silence Active 1=yes
18
Trouble Silence Active 1=yes
19
AC Power on Main Board 1=ok
20
AC Power on Aux Board 1=ok
21
Walk test Condition 1=on
22
Ground Fault Condition 1=ok
23
Ack Condition 1=on
24
Date & Time
Month
