Triangle Tube’s ProtoNode Startup Guide
Page 22 of 40
ProtoCessor
1991 Tarob Court Milpitas, California 95035 USA
Web
Figure 19: Changing IP Address via FST Web GUI
•
From the Web Configurator landing page (
Figure 18
)
, click on the “Diagnostics & Debugging” button in
the bottom right side of the page to access the FST Web GUI.
•
The FST Web GUI page will be presented.
•
From the FST Web GUI’s landing page, click on “Setup” to expand the navigation tree and then select
“Network Settings” to access the IP Settings menu. (
Figure 19
)
•
Enter the new IP address for the ProtoNode’s Ethernet port in the “N1 IP address” field.
•
If necessary, change the Subnet Mask setting in the “N1 Netmask” field.
•
If necessary, change the IP Gateway setting in the “Default Gateway” field.
•
Note: If the ProtoNode is connected to a router, the IP Gateway of the ProtoNode should be set to the
IP address of the router that it is connected to.
•
Click the “System Restart” button at the bottom of the page to apply changes and restart the
ProtoNode.
•
Unplug Ethernet cable from PC and connect the ProtoNode to the network hub or router.
•
Record the IP address assigned to the ProtoNode for future reference.
4.4 BACnet/IP and Modbus TCP: Setting IP Address for Field Network
