3
3-7
Performing Setup from WebSetup
Ethernet (Port Setup)
Enable Ethernet
—Select
Yes
if the Fiery X2 is to be connected to an Ethernet network.
Transmission Speed
—Select
Auto Detect
if your network environment is mixed, or
select the speed (10 Mbps or 100 Mbps) of the network to which the Fiery X2 is
attached.
Parallel Port (Port Setup)
Enable Parallel Port
—Select
Yes
if you want to print through the parallel port. You
can connect a single Windows computer to the parallel port and print directly to the
Fiery X2.
N
OTE
:
Enabling the parallel port does not conflict with using Ethernet or Token Ring
communication with the Fiery X2.
Ignore EOF Character
—Available only if
Enable Parallel Port
is set to
Yes
, this option
specifies that the Fiery X2 should ignore end-of-file (EOF) messages.
Yes
is required to
print PostScript files in binary format (not ASCII); under normal circumstances, it
should be set to
No
. When this option is set to
Yes
, the Fiery X2 uses the parallel port
timeout value to determine when the end of the file has been reached.
Parallel Port Timeout (Seconds)
—Available only if
Enable Parallel Port
is set to
Yes
,
your setting determines how long the Fiery X2 waits without receiving data from the
parallel port before deciding that the current job is complete. Until the timeout, the
Fiery X2 cannot receive new jobs through the parallel port, but it can continue to
receive network print jobs.
Token Ring (Port Setup)
Enable Token Ring
—Select if the Fiery X2 is to be connected to a Token Ring net-
work.
Maximum Frame Size
—Select the maximum frame size recommended by the network
administrator at your site. If you are uncertain of the setting to use, select the default
value (4202).
Enable Source Routing
—Click to select if your network supports source routing.
Request All Routes
—This option is active only if you enabled Source Routing. Click
to select if you want the Request packet to travel to its destination by all routes.
