4
4-24
Setting up Network Servers
T
O
CONNECT
AND
TO
THE
F
IERY
X2
SHARED
BY
THE
W
INDOWS
NT 4.0
SERVER
:
•
For Windows NT 4.0 Workstation clients, before printing, connect to the print server
computer and select the Fiery X2. Right mouse click and choose the Open command.
When prompted, click Yes to have Windows set up the printer.
After clients have selected the printer, they can choose it from the Print Setup, Page
Setup or Print dialog box of their application. Clients can change printing options for
their own job, but printer properties are grayed and not available for changing. When a
client chooses Print, the job is transmitted to the Windows NT 4.0 print server, and
from there to the selected queue on the Fiery X2. The job is listed in the Print Manager
on the client workstation, and the administrator can track it in the Fiery X2 window in
the Print Manager on the Windows NT 4.0 print server.
Configuring Windows NT 4.0 workstations for the Fiery utilities
To run the Fiery utilities on a TCP/IP network, the workstation must be running
Windows NT 4.0 Server or Windows NT 4.0 Workstation, with Microsoft TCP/IP
protocols loaded and bound to the network driver.
T
O
ENABLE
THE
F
IERY
UTILITIES
ON
THE
F
IERY
X2:
1.
Perform Fiery X2 Setup and enable TCP/IP.
In Network Setup, choose Protocol Setup and perform TCP/IP Setup and Ethernet
Setup. (Perform Token Ring Setup if the Token Ring option is installed.) Enabling
TCP/IP automatically enables the communication for the Fiery utilities.
2.
Set a valid, unique IP Address for the Fiery X2, and then set the subnet mask and a
gateway address if necessary.
Before you exit Network Setup, you can also choose Service Setup and enable
Web Services (see page 4-25).
3.
Save changes after Setup.
Performing these steps once enables the connection for all users on the TCP/IP net-
work.
See Getting Started for information on installing the Fiery utilities and configuring the
connection to the server.
