Permanent Winch Mounting
Select a mounting site on the boat trailer, vehicle
bumper, truck bed, or other suitable location.
Align the winch perpendicular to the center line of
the vehicle at the desired location. Use mounting
holes in the winch as a template to mark for drilling
mounting holes in the installation surface.
Before drilling, make sure that there are no hidden
components or structural pieces that will be
damaged in the installation surface.
Drill 3/8'' holes at the marked locations.
Bolt the winch to the installation surface with 3/8''
bolts, nuts, and washers (not included).
Note:
1. This winch can generate extreme forces. Select a location that can withstand the rated capacity
without damage or weakening.
2. This winch is not intended for use underwater. Do not mount in locations that are subject to
submersion in water.
Attaching the Hand Crank
Remove the outer lock nut on the thread shaft.
Tighten the clutch knob and the inner lock nut.
Slide the hand crank over the thread shaft up against the inner lock nut.
Secure the hand crank in place with the outer lock nut.
Outer Lock Nut
Outer Lock Nut
Hand Crank
Clutch Knob
Inner Lock Nut
