Unloading the boat:
If not previously done, attach the winch cable hook to the bow eye on the boat.
Connect the power to the winch.
Connect the wired remote.
Remove the tie down straps from the boat.
By pressing the OUT switch on the remote control, power out the cable until the boat is unloaded.
When the boat is in the water, release the cable hook.
While maintaining tension in the cable, press the IN switch on the remote control to roll the cable up
completely. DO NOT allow the cable to roll up loosely or allow the cable hook to roll into the winch as
damage to the cable and winch components could occur.
To prevent accidents, secure the cable hook, disconnect the power supply and the remote control after use.
Stopping the Boat Winch in Emergency
When you need to stop the electric boat winch in emergency, simply pull the rotary knob.
Using the Pulley Hook
Unscrew the nut on the pulley block and remove the
bolt which secures the pulley wheel.
Remove the pulley wheel and insert the winch cable in
the pulley.
