FIKE CORPORATION
EQUIPMENT
U.L. S2203
Expanded Enclosures Installation Guide
Page 7 of 23
F.M. 3009544
Manual P/N: 06-185
Revision No: 1, 11/01
VESD
A PC LINK H
LI
10-2277 HLI
10-2345
Optional Mounting Plate,
Cheetah/VESDA High Level
Interface (HLI)
This kit provides a stainless steel mounting plate, mounting
hardware, 10-2277 Cheetah/VESDA High Level Interface
(HLI) printed circuit board assembly, 02-3053 RS-232 cable,
and Cheetah/VESDA interface manual. It is approximately
12” (30.5 cm) wide by 11” (27.94 cm) high.
10-2346
Optional Mounting Plate,
VESDA LaserCompact
This kit provides a stainless steel mounting plate and necessary
mounting hardware, to install a VESDA Compact unit, P/N 68-
040/68-041 (sold separately). Due to sampling pipe requirements
the plate must be mounted in the bottom bay of the two bay
enclosure and either the middle or bottom bay of the three bay
enclosure. Holes are provided on the enclosure to facilitate
exhaust requirements for the Compact unit. Use the supplied
grommets to cover the edges of the exhaust holes. It is
approximately 12” (30.5 cm) wide by 11” (27.94 cm) high.
10-2347 Optional Mounting Plate,
4” Square Addressable Modules
This kit provides a stainless steel mounting plate and necessary
mounting hardware to install up to six each 4" square modules
(sold separately) without covers. It is approximately 12" (30.5 cm)
wide by 13 1/2" (34.29 cm) high.
10-2348 Optional Mounting Plate, Battery
This kit provides a stainless steel mounting plate and necessary
mounting hardware for securing plate to enclosure. This plate will
support up to two each of 18 Amp-Hour batteries (sold separately).
It brings the batteries up off of the bottom of the enclosure to provide
accessibility to the bottom knock-outs on the enclosure. It is
approximately 12" (30.5 cm) wide by 11" (27.94 cm) high by 3 1/2"
(8.89 cm) deep.
Grommet
Qty. 2 for encl.
exhaust holes