INSTALLATION
FIKE CORPORATION
Page 22 of 23
Expanded Enclosures Installation Guide
U.L. S2203
Revision No: 1, 11/01
Manual P/N 06-185
F.M. 3009544
Fike
Mounting
Plate
Possible
grommet location
Possible
grommet location
Enclosure
#6-32 Hex Nut
w/ Washer
Typ. 4 Plcs.
Vesda
LaserCompact
68-040 or
68-041
Sold Separately
VE
SD
A PC L
INK
HL
I
10-2277 HLI
Mounting
Plate
Back / inside of
Enclosure
#6-32 Screw
Typ. 4 Plcs.
#6-32 Hex Nut
w/ Washer
Typ. 4 Plcs.
10-2345 - High Level Interface Assembly
Attach mounting plate to enclosure using the
hex nuts and washers provided. Secure
Cheetah/VESDA HLI with screws and washers
at each corner as shown.
10-2346 - VESDA LaserCompact
Mounting Plate
The Compact unit can only be mounted in
the bottom bay of the 2-bay enclosure and
the middle or bottom bay of the 3-bay
enclosure. Determine the direction of the
VESDA Compact unit (sold separately)
before installing the mounting plate (can be
mounted up or down). Mount with side tabs
facing up or down to support direction of
compact. Attach to enclosures with hex nu
and washers as shown. Grommet should
be inserted in hole provided on enclosure t
support exhaust requirements.
5.4.2 Optional Mounting Plate Assemblies
These plate assemblies provide an easy way of attaching control boards, modules or batteries to the
expanded enclosure. Refer to Section 3.1 for product information. Mounting hardware for the plate
as well as the electronic component the plate supports is included in the plate assembly. All plates
are mounted flush against the back box to the 6-32 threaded press stud. Secure the plates with the
lock washers and hex nuts provided as shown in section 5.2.