6.0 SYSTEM MAINTENANCE
UL S2203
CyberCat 254/1016 Operation Manual
6-5
FM
P/N: 06-326-2
Rev 6, 09/2015
The panel will indicate that it has detected a new device and will record a new device message in the history
buffer. Once the ENTER button is pressed, the panel will record the device with the new address (the panel
will auto-increment the address number after each successful address write):
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0
A
C O N N E C T D E V I C E T O
B
A D D R E S S A B L E L O O P
C
* N E W D E V I C E *
D
* D E T E C T E D *
Exhibit 6-7: Device Address/New Device Screen
After each successful address write, the panel will indicate that the process has been completed and will
prompt the user to press the ENTER button to address the next device. The panel will increment to the next
device address automatically after the ENTER button has been pressed:
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0
A
L O O P : 1
A D D R E S S : N N N
B
D E V I C E A D D R
C H A N G E
C
C O M P L E T E D
D
E N T E R F O R N E X T
D E V I C
Exhibit 6-8: Device Address/Change Screen
Note:
Row C will display “FAILED” if an error occurred during the write process.
6.4.1.3
DEVICE REPLACE
The Device Replace screen allows you to replace a sensor type device already connected to the panel with a
new (like) device and write the configuration of the original device into the new device. A successful Level 2
or higher password is required to access this feature. From the Maintenance Menu, press the F3 button to
access the Device Replace screen:
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0
A
S E L E C T A D D R E S S
B
L O O P : 1 A D D R E S S : 0 0 1
C
T Y P E : P H O T O S E N S O R
D
P R E S S E N T E R T O S T A R T
Exhibit 6-9: Device Replace Menu
•
Row B - Allows you to select the loop and address of the device to be replaced. Use the
◄►arrow buttons to move the cursor under the Loop and Address fields; then use the +/- buttons
to increment/decrement the fields.
•
Row C - Displays the type of device associated with the Loop and Address selected in Row B.
•
Row D - Press the ENTER button to start the device replace function.
Note:
The replacement device MUST be the same type of device as the device being replaced. Testing
of the changed device is recommended after replacement.
Note:
This process requires a device originally connected with a valid configuration. It is useful for fixing
maintenance troubles, but not DEVICE MISSING or DEVICE ERROR: 2000 troubles. C-Linx should be
used for sending configurations.
Summary of Contents for CyberCat 1016
Page 135: ......
