REV.
A
11
‐
25
‐
2019
Filabot
Vermont, USA, Earth
1-802-505-6772
Filabot Reclaimer
Operation Manual
This manual applies to the Filabot Reclaimer.
Triex LLC, Barre, VT 05641, USA
1
CAUTION! Read Carefully
HEAVY
Fully assembled Reclaimer weighs 125lbs. DO NOT attempt
to lift or assemble the Reclaimer alone.
SHARP ROTATING BLADES
Never operate the Reclaimer with out
all hoppers closed and secured. Never operate the Reclaimer if any
parts appear missing or damaged. NEVER ATTEMPT TO MODIFY
OR BYPASS SAFETY SWITCHES OR CIRCUITRY.
SHARP PLASTIC SHRAPNEL
Crushing, cutting, or otherwise
breaking down plastics such as PLA and others will create high
speed projectiles and sharp edges. Always wear proper eyewear and
gloves when working with the Reclaimer and processing plastic.
In Case of Emergency
hit the EMERGENCY STOP button or pull
the power cord out of the machine.
Only use the Reclaimer to process thermoplastic polymers. No other
use has been tested or approved by Filabot.
Always STOP the Reclaimer before opening the hoppers.
The Reclaimer is designed for indoor use only. Operate in a clean,
dry area.
Check the AC input voltage specified on the S/N Label near the
power inlet. Only use the specified input voltages to operate the
Reclaimer or damage to the components will occur.
Do not use this device if any parts appear missing or damaged.
Do not modify this device without authorization from Filabot.
Contact Filabot with any questions
1-802-505-6772
contact@filabot.com
