BRUSHES SETS MENU (PARAMETERS)
Proceed as follows to view the “BRUSHES SETS” menu:
1.
Display the "MACHINE BRUSHES SETTINGS" menu - see
.
2.
Display the “SERVICE” menu - see
.
3.
Display the “PARAMETERS” menu - see
“PARAMETERS MENU (SERVICE)” on page 17
.
4.
Using buttons (1) and (2) (
Fig.1
) select the "BRUSHES SETS" screen (
Fig.2
) and press button (3) to confirm
the display (
Fig.1
).
2
1
1
Brushes
sets...
2
-SETTINGS-
N.B.:
in the parameters menu, the display is only shown in English.
The following sub-menus can be selected on the Brushes menu screen:
BRUSH MOT
Used to modify the parameter relating to the standby time before the actuator moves the
scrubbing brush head to the "lifted off the floor" position - see
(BRUSHES BRUSH MOT)” on page 35
Used to modify the parameter relating to the reset voltage after an ammeter protection tripping
condition - see
“SPEED REDUCTION MENU (BRUSHES BRUSH MOT)” on page 36
.
Used to modify the parameter relating to the pressure levels exerted on the scrubbing brush
head - see
“PRESSURE LEVEL MENU (BRUSHES BRUSH MOT)” on page 37
.
Used to modify the parameter relating to the maximum current interval permitted for the
pressure levels prior to the tripping of the ammeter protection - see
MENU (BRUSHES BRUSH MOT)” on page 38
.
SWEEP MOT
Used to modify the parameter relating to the standby time before the actuator moves the
sweeping brush head into the "lifted off the floor" position - see
(BRUSHES SWEEP MOT)” on page 39
.
Used to modify the parameter relating to the reset voltage after an ammeter protection tripping
condition - see
“SPEED REDUCTION MENU (BRUSHES SWEEP MOT)” on page 40
Used to modify the parameter relating to the pressure level exerted on the sweeping brush
head - see
“PRESSURE LEVEL MENU (BRUSHES SWEEP MOT)” on page 40
.
Used to modify the parameter relating to the maximum current interval permitted for the
pressure levels prior to the tripping of the ammeter protection - see
MENU (BRUSHES SWEEP MOT)” on page 41
.
Page 34
