PUMP LEVEL MENU ( WATER PUMP)
Proceed as follows to change the "PUMP LEVEL” parameter in the water menu:
1.
Display the "MACHINE BRUSHES SETTINGS" menu - see
.
2.
Display the “SERVICE” menu - see
.
3.
Display the “PARAMETERS” menu - see
“PARAMETERS MENU (SERVICE)” on page 17
.
4.
Display the “PUMP SETS” menu - see
“PUMP SETS MENU (PARAMETERS)” on page 43
.
5.
Display the “WATER” menu, see
“WATER MENU (PUMP SETS)” on page 43
6.
Using buttons (1) and (2) (
Fig.1
) select the "PUMP LEVEL" screen (
Fig.2
).
7.
As soon as the “PUMP LEVEL” screen (
Fig.2
) is displayed, select the percentage of detergent solution
dispensed by the machine during the work phase using buttons (3) and (4) (
Fig.1
).
N.B.:
the selected value will be visible in the text string (5) in the lower part of the screen (
Fig.2
).
8.
Confirm the selection by pressing the button (6) (
Fig.1
).
Pump
Water
40
[%]
Pump level 1:
min:0
max:150
2
5
2
4
1
3
6
1
N.B.:
the “PUMP LEVEL (Sum)” parameters represent the quantity of detergent solution that is delivered by
the machine while working.
N.B.:
the “PUMP LEVEL (Sum)” parameters are expressed as a percentage (%) of the maximum flow rate of
the pump in the machine's water system. The numerical value is between a minimum of 0 and a maximum of
150, and the selectable increment is two units.
N.B.:
the “PUMP LEVEL (Sum)” parameters are set to the following numbers in the factory:
•
PUMP LEVEL #1 (Sum)= 50
•
PUMP LEVEL #2 (Sum)= 70
•
PUMP LEVEL #3 (Sum)= 90
CHEMICAL MENU (PUMP SETS)
Proceed as follows to view the “CHEMICAL” menu:
1.
Display the "MACHINE BRUSHES SETTINGS" menu - see
.
2.
Display the “SERVICE” menu - see
.
3.
Display the “PARAMETERS” menu - see
“PARAMETERS MENU (SERVICE)” on page 17
.
4.
Display the “PUMP SETS” menu - see
“PUMP SETS MENU (PARAMETERS)” on page 43
.
5.
Using buttons (1) and (2) (
Fig.1
) select the "CHEMICAL PUMP" screen (
Fig.2
) and press button (3) to confirm
the display (
Fig.1
).
Page 44
