RESET DELAY MENU (OPTIONAL OPT. BRUSH)
Proceed as follows to change the “RESET DELAY” parameter in the brush motor menu:
1.
Display the "MACHINE BRUSHES SETTINGS" menu - see
2.
Display the “SERVICE” menu - see
3.
Display the “PARAMETERS” menu - see
“PARAMETERS MENU (SERVICE)” on page 17
4.
Display the “OPTIONAL SETS” menu - see
“OPTIONAL SETS MENU (PARAMETERS)” on page 50
.
5.
Display the “OPT. BRUSH” menu, see
“OPT. BRUSH MENU (OPTIONAL SETS)” on page 50
.
6.
Using buttons (1) and (2) (
Fig.1
) select the "RESET DELAY" screen (
Fig.2
).
7.
As soon as the “RESET DELAY” screen (
Fig.2
) is displayed, select the delay in seconds before the actuator
brings the side brush to the "raised from the floor" position using buttons (3) and (4) (
Fig.1
).
N.B.:
the selected value will be visible in the text string (5) in the lower part of the screen (
Fig.2
).
8.
Confirm the selection by pressing the button (6) (
Fig.1
).
Optional accessories
Opt. Brush
20
[s]
Reset delay:
min:1
max:300
2
5
2
4
1
3
6
1
N.B.:
the “RESET DELAY” parameter is a time interval during which the side brush remains in the working
position before lifting off the ground.
N.B.:
The “RESET DELAY” parameter is expressed in seconds (s), the numerical value is between a
minimum of 001 and a maximum of 300, the selectable increment is one unit.
N.B.:
The “RESET DELAY” parameter is set in the factory to 20.
Page 51
