24
WORK
During the first few meters, check that the speed is appropriate to the work to be carried out; if not, adjust
after reading the section "ADJUSTING WORKING SPEED" (valid only for BT versions).
During the first few meters, check that the detergent solution is appropriate to the work to be carried out; if
not, adjust after reading the section "ADJUSTING DETERGENT SOLUTION".
The machine will now begin to work with full efficiency until the battery is flat or until the detergent solution
has finished.
If the dead man's lever is released during the scrubbing operation with drying function, the traction motor
(BT version), the brush motor and the solenoid valve will stop working; the vacuum motor will continue to
function for a period of about fifteen seconds and then be switched off. On the control display, the "A"
symbol will remain visible.
WARNING: In order to recommence work, simply press the dead man's lever and
the traction motor (BT version), brush motor, vacuum motor and solenoid valve will
restart.
If only the scrubbing function is needed, simply press the button (08) on the control panel and the vacuum
motor will stop working immediately after approximately fifteen seconds. On the control display the "A"
symbol will disappear and the "O" symbol will appear.
Once the scrubbing cycle is complete, press the button (08) to go back over and dry the scrubbed
surface.
If during the scrubbing operation the dead man's lever is released, the traction motor (BT version) will
stop working, the brush motor and the solenoid valve will cease to function. On the control display, the "O"
symbol will remain visible.
WARNING: In order to recommence work, simply press the dead man's lever and
the traction motor (BT version), brush motor and solenoid valve will restart.
If only the scrubbing function is needed without detergent solution, simply press the button (09) on the
control panel and hold for a few seconds; the solenoid valve will stop working and the detergent solution
supply will cease.
Once the scrubbing cycle without detergent solution is complete, to go back over and dry the scrubbed
surface press the button (09) to adjust the release of detergent solution (read paragraph "ADJUSTING
DETERGENT SOLUTION”).
If the dead man's lever is released during the scrubbing operation without detergent solution, the traction
motor (BT version) and the brush motor will stop working; the vacuum motor will continue to function for a
period of about fifteen seconds and then be switched off. On the control display, the "O" symbol will
remain visible.
WARNING: In order to recommence work, simply press the dead man's lever and
the traction motor (BT version), brush motor and vacuum motor will restart.
