25
WORK
If only the drying function is needed, simply press the button (06) on the control panel and the brush
motor, the vacuum motor and the solenoid valve will stop working immediately (the vacuum motor will
effectively cease to function after approximately fifteen seconds). On pressing the button (08) the vacuum
motor will start up again, and the machine can be used in drying mode. On the display, the “O” symbol will
disappear, and the text “ASP” will appear. Once the drying cycle is complete, press the button (06) to go
back over and dry the scrubbed surface.
If the dead man's lever is released during the drying operation, the traction motor (BT version) will stop
working; the vacuum motor will continue to function for a period of about fifteen seconds and then be
switched off. On the control display, the "ASP" symbol will remain visible.
WARNING: In order to recommence work, simply press the dead man's lever and
the traction motor (BT version) and vacuum motor will restart.
26.
PREPARING TO WORK (BB VERSIONS)
Before beginning to work, it is necessary to:
1.
Make sure the recovery tank is empty, otherwise empty it completely.
2.
Check that the quantity of detergent solution in the solution tank is correct for the type of work to be
carried out; if not, refill the solution tank.
3.
Make sure that the main switch (01) is in the "0" position; if not, position it to "0".
4.
Connect the electric system connector (02) to the battery connector.
5.
Check that the detergent solution tap is fully open; if not, turn the lever (03) on the rear of the machine.
6.
Place the main switch (01) in position "I”. The battery and hour meter display will activate immediately.
7.
Turn the vacuum motor control switch (04) to “Pos.-01”. The motor will start up immediately.
WARNING: If the dead man's lever is activated during start up, the machine will
begin to function; during the machine start up phase it is advisable to release the
dead man's lever.
8.
Lower the squeegee body by means of the lever (05) on the back of the machine.
9.
On activation of the dead man's lever, the machine will begin to move.
During the first few meters, check that the detergent solution is appropriate to the work to be carried out; if
not, adjust after reading the section "ADJUSTING DETERGENT SOLUTION".
The machine will now begin to work with full efficiency until the battery is flat or until the detergent solution
has finished.
If the dead man's lever is released during the scrubbing with drying operation, the brush motor and
solenoid valve will cease to function; the vacuum motor will continue to work until the button (04) is in
position "Pos.-02".
WARNING: In order to recommence work, simply press the dead man's lever and
the brush motor and solenoid valve will restart. Press the button (04) to activate the
vacuum motor if previously switched off.
