33
AT THE END OF WORK
38.
AT THE END OF WORK (BB VERSIONS)
At the end of work, and before carrying out any type of maintenance, perform the following operations:
1.
Switch off the vacuum motor using the switch (01) positioned on the rear of the machine.
2.
Switch off the power supply to the machine's electrical system using the main switch (02) located on
the rear of the machine, turning the key to position “0”.
3.
Raise the squeegee body from the ground by means of the lever (03) on the back of the machine.
4.
Take the machine to the place provided for draining off the dirty water.
5.
Disconnect the electrical connector (04) from the battery connector.
WARNING: Before performing any maintenance, remove the keys from the
panel and disconnect the battery connector of the machine.
6.
Disconnect the recovery tank drainage tube (5) from its housing, unscrew the drainage cap and empty
the recovery tank. On completion of the operation, tighten the cap and position the tube (05) in its seat.
WARNING: This operation must be carried out wearing gloves to protect
against contact with dangerous solutions.
WARNING: To avoid damaging the machine or creating foul odours, it is
advisable to empty the tanks every time the machine is switched off.
7.
Remove the vacuum hose (07) from the sleeve (08) on the squeegee body.
8.
Loosen the knobs (09) in the squeegee body pre-assembly.
9.
Remove the squeegee body from the slits in the squeegee connector.
10.
First with a jet of water and then with a damp cloth, thoroughly clean the vacuum chamber of the
squeegee body, the rear rubber blade and the front rubber blade.
