PREPARATION OF THE APPLIANCE
10.
BATTERY CHARGER CONNECTION (only for systems with CB)
In order not to cause permanent damage to individual battery elements, it is essential to avoid their complete discharge by recharging them within a few
minutes from the "discharged battery" warning light being switched on.
ATTENTION: Never leave individual battery elements completely discharged, even if the appliance is not in operation. Check the
battery charger is suitable for the batteries installed, in terms of both capacity and type.
To connect the battery charger you must:
1.
Move the appliance to the designated battery charging area.
ATTENTION: Park the device in an area protected from the elements and with suitable ventilation, on a flat and level surface.
There must be no objects near the device that could either damage it, or be damaged through contact with it.
2.
Check that the recovery tank is empty; if not, empty it using the tube provided for this purpose (1) positioned at the rear of the device (read the
section "
EMPTYING THE RECOVERY TANK
").
3.
Check that the main switch is in the “0” (2) position. If this is not the case, turn the key by a quarter of a turn to the left. Remove the key from the
instrument panel.
4.
Check that the brush head unit is raised from the floor, if necessary turn the pedal (3) at the bottom of the device anticlockwise.
5.
Check that the squeegee unit is raised from the floor; if necessary use the lever (4) at the rear of the device.
6.
For BT versions, check that the parking brake is on. If this is not the case, rotate the lever (5) in the sense shown by the picture.
7.
Remove the recovery tank using the hinge (6).
8.
Grip the handle (7) on the rear left side of the recovery tank and turn the recovery tank until it reaches the end position.
9.
Open the drawer by pressing on the handle (8) located on the rear of the appliance.
10.
Connect the battery charger cable to the socket on the charger itself.
11.
Plug the battery charger cable into the mains socket.
WARNING: Keep the recovery tank open for the duration of the battery recharging cycle to allow gas fumes to escape.
WARNING: The room used to recharge the batteries must be adequately ventilated to prevent the accumulation of gases that leak
from batteries.
WARNING: Carefully read the use and maintenance manual of the charger that is delivered inside the bag containing this instruction
booklet.
WARNING: Before inserting the charger power cable into the socket, verify that there is no condensate or other forms of liquids.
ATTENTION: If the device's electrical system is inadvertently powered, the "POWER PLUG" symbol will be displayed on the top left
side of the control display. No controls will be operational whilst the battery is being charged.
Page 13
