PREPARATION OF THE APPLIANCE
18.
BRUSH ASSEMBLY (only for single-disc versions)
For packaging reasons, the brush is supplied disassembled from the device, and must be assembled as follows:
1.
Take all necessary steps to ensure that the device is in a safe condition (see “
MACHINE SAFETY
”).
2.
Grip the handle (1) on the rear left side of the recovery tank and turn the recovery tank until it reaches the work position.
3.
Secure the recovery tank with the hinge (2).
4.
With the brush head detached from the floor, place the brush into the body underneath the brush head.
5.
Lower the brush head unit positioning it onto the brush by activating the brush head unit control pedal (3).
6.
Rotate the brush until the coupling system in the brush plate locks with the brush locking system (for MMx 43 versions).
7.
Rotate the brush until the three buttons in the brush enter into the notches in the brush plate (for MMx 50 versions).
8.
To lock, click them into position by turning them anticlockwise to the direction of travel.
9.
For the MMx 43 version, reassemble the brush head splash guard (read the paragraph“
BRUSH HEAD SPLASH GUARD ASSEMBLY
”).
WARNING: you are advised to always wear protective gloves, to avoid the risk of serious injury to your hands.
19.
BRUSH ASSEMBLY (only for twin-disc versions)
For packaging reasons, brushes are supplied disassembled from the appliance, and must be assembled as follows:
1.
Take all necessary steps to ensure that the device is in a safe condition (see “
MACHINE SAFETY
”)
2.
Grip the handle (1) on the rear left side of the recovery tank and turn the recovery tank until it reaches the work position.
3.
Secure the recovery tank with the hinge (2).
4.
With the brush head detached from the floor, place the brush into the body underneath the brush head.
5.
Lower the brush head unit, positioning it onto the brushes by activating the brush head unit control pedal (3).
6.
Rotate the brush unit the brush's three buttons grip with the notches in the brush plate.
7.
To lock, click them into position by turning them anticlockwise to the direction of travel for the right-hand brush and clockwise for the left-hand
brush.
8.
Reassemble the brush head splash guard (read the paragraph“
BRUSH HEAD SPLASH GUARD ASSEMBLY
”).
WARNING: you are advised to always wear protective gloves, to avoid the risk of serious injury to your hands.
Page 17
