DAILY MAINTENANCE
5.
CLEANING THE VACUUM MOTOR FILTER FLOAT
Careful cleaning of the recovery tank filter guarantees better cleaning of the floor as well as a longer vacuum motor life. Proceed as follows to clean the
recovery tank filter:
1.
Take the device to the dedicated maintenance area.
2.
Take all necessary steps to ensure that the device is in a safe condition (see “
MACHINE SAFETY
”)
3.
Grip the handle (1) on the rear left side of the recovery tank (work direction) and turn the recovery tank until it reaches the work position.
4.
Secure the recovery tank with the hinge (2).
5.
Grip the handle (3) on the front side of the vacuum cap, rotate the vacuum cap until the hook (4) is secured to the recovery tank's prop (5).
6.
Remove the vacuum filter protection (6) by rotating it in a clockwise direction. Release the retaining clips (7). Take the vacuum filter out of the
housing (8), clean the walls and the bottom of the filter with a jet of water, remove any dirt that is attached.
7.
Repeat the operations in reverse order to reassemble all the parts.
WARNING: You are advised to always wear protective gloves, to avoid the risk of serious injury to your hands.
WARNING: The place this operation is carried out should comply with current environmental protection regulations.
6.
CLEANING THE SOLUTION TANK FILTER
The careful cleaning of the solution tank filter guarantees a longer life span of the appliance's water circuit system, ensuring a better floor cleaning
performance. Proceed as follows to clean the solution tank's filter:
1.
Take the device to the dedicated maintenance area.
2.
Take all necessary steps to ensure that the device is in a safe condition (see “
MACHINE SAFETY
”)
3.
Grip the handle (1) on the rear left side of the recovery tank (work direction) and turn the recovery tank until it reaches the work position.
4.
Secure the recovery tank with the hinge (2).
5.
Loosen the drain cap (3) and clean it with clean running water; where needed, remove any impurities from it.
6.
Repeat the operations in reverse order to reassemble all the parts.
WARNING: You are advised to always wear protective gloves, to avoid the risk of serious injury to your hands.
WARNING: The place this operation is carried out should comply with current environmental protection regulations.
Page 26