WEEKLY MAINTENANCE
3.
CLEANING THE VACUUM HOSE
Careful cleaning of the vacuum hose guarantees better cleaning of the floor as well as a longer vacuum motor life. Proceed as follows to clean the
vacuum hose:
1.
Take the device to the dedicated maintenance area.
2.
Take all necessary steps to ensure that the device is in a safe condition (see “
MACHINE SAFETY
”).
3.
Grip the handle (1) on the rear left side of the recovery tank (work direction) and turn the recovery tank until it reaches the work position.
4.
Secure the recovery tank with the hinge (2).
5.
Remove the vacuum hose (3) from the vacuum nozzle (4) on the squeegee body.
6.
Grip the handle (5) on the front side of the vacuum cap, rotate the cap (6) until the hook (7) is secured to the recovery tank's prop (8).
7.
Clean the inside with a jet of water, inserting the hose in the part of the vacuum nozzle (8) fixed to the recovery tank.
8.
Repeat the operations in reverse order to reassemble all the parts.
WARNING: You are advised to always wear protective gloves, to avoid the risk of serious injury to your hands.
WARNING: The place this operation is carried out should comply with current environmental protection regulations.
4.
CLEANING THE DETERGENT CANISTER (only for system with FSS)
Careful cleaning of the detergent canister ensures improved floor cleaning performance as well as a longer water circuit system life span. To clean the
canister, proceed as follows:
1.
Take all necessary steps to ensure that the device is in a safe condition (see “
MACHINE SAFETY
”).
2.
Remove the cap (1) of the detergent canister (2).
3.
Remove the detergent canister (2) from the solution tank compartment.
4.
Rinse the inside of the canister with a jet of running water.
5.
Repeat the operations in reverse order to reassemble all the parts.
WARNING: The place this operation is carried out should comply with current environmental protection regulations.
WARNING: Do not throw the detergent directly into the drain, but comply with current environmental protection regulations.
ATTENTION: Screw on the cap (1) of the detergent canister (2), making sure that the detergent suction filter (3) is correctly
positioned on the bottom of the canister.
Page 28