EXTRAORDINARY MAINTENANCE
4.
REPLACING THE BRUSH HEAD SPLASH GUARD
The brush head splash guard's integrity ensures better floor cleaning performance, as well as a longer brush motor life span. To replace the brush head
splash guard, proceed as follows:
1.
Take all necessary steps to ensure that the device is in a safe condition (see “
MACHINE SAFETY
”).
2.
Grip the handle (1) on the rear left side of the recovery tank and turn the recovery tank until it reaches the work position.
3.
Secure the recovery tank with the hinge (2).
4.
Lower the brush head unit positioning it onto the brushes by activating the brush head unit control pedal (3).
5.
Unhook the hook (4) of the spring from the fastening screw on the right-hand side of the brush head (direction of work).
6.
Remove the fixing strip (5) of the rubber splash guard.
7.
Replace the old splash guard with the new one (read paragraph "
ASSEMBLING THE BRUSH HEAD SPLASH GUARD
").
WARNING: you are advised to always wear protective gloves, to avoid the risk of serious injury to your hands.
5.
RINSING THE DOSING SYSTEM (only for FSS system)
If the appliance is not used for long periods of time (more than 48 hours), it is recommended that the dosing system should be rinsed. To do this,
proceed as follows:
1.
Take the device to the dedicated maintenance area.
2.
Take all necessary steps to ensure that the device is in a safe condition (see “
MACHINE SAFETY
”).
3.
Remove the cap (1) of the detergent canister (2).
4.
Remove the detergent canister (2) from the solution tank compartment.
5.
Remove any detergent residue. Rinse the inside of the canister with a jet of running water. Fill the canister with clean water
6.
Tighten the screw cap (1) properly to prevent liquid from leaking during operation, and ensure that the detergent suction filter (3) is correctly
positioned at the bottom of the canister.
7.
Put the canister (2) back into the solution tank compartment.
WARNING: The place this operation is carried out should comply with current environmental protection regulations.
WARNING: Do not throw the detergent directly into the drain, but comply with current environmental protection regulations.
WARNING: You are advised to always wear protective gloves, to avoid the risk of serious injury to your hands.
Page 31
