TROUBLESHOOTING
1.
AN ALARM MESSAGE APPEARS ON THE CONTROL DISPLAY
If, when starting or using the appliance, a warning message appears on the control display, stop the appliance immediately and contact the technician
at the dedicated Technical Service Centre.
2.
THE APPLIANCE DOES NOT SWITCH ON
1.
Check that the main switch is in the "I" position; if this is not the case, turn the key (1) by a quarter of a turn to the right.
2.
Make sure that, when starting the machine, NO alarm message appears on the control display; read the paragraph “
AN ALARM MESSAGE
APPEARS ON THE CONTROL DISPLAY
”.
3.
Check that the battery (2) is connected to general system connector (3); if not, connect them together.
4.
Check the battery charge level, check the symbol on the control display. If the charge level of batteries is critical, go through a full charge cycle
(read the paragraph“
CONNECTING BATTERIES (only for systems without battery charger)
” or “
CONNECTING BATTERY CHARGER (only for
systems with battery charger)
”).
WARNING: If all these procedures do not solve the problem, contact the technician at the dedicated Technical Service Centre.
3.
THE BATTERIES ARE NOT CHARGED CORRECTLY
1.
Check that the battery (1) is connected to general system connector (2); if not, connect them together.
2.
Check that the battery charger used is suitable for the batteries in the appliance and is correctly set up for the batteries used.
3.
Referring to the battery charger use and maintenance manual, check the meaning of the flashing signals that the battery charger emits dung the
battery recharge stage.
WARNING: If all these procedures do not solve the problem, contact the technician at the specialist technical assistance centre.
4.
THE DEVICE HAS A VERY LOW OPERATING AUTONOMY
1.
Check that there is water in the solution tank; the level in the tank checked using a level indicator (1) on the left rear of the device.
2.
Check the battery charge level, check the symbol on the control display. If the charge level of batteries is critical, go through a full charge cycle
(read the paragraph“
CONNECTING BATTERIES (only for systems without battery charger)
” or“
CONNECTING BATTERY CHARGER (only for
systems with battery charger)
”).
Page 33
