37
EXTRAORDINARY MAINTENANCE
ATTENTION: This operation must be carried out using gloves to protect
against contact with dangerous solutions.
4.
Use a suitable tool to remove the side splash guard (4), loosening the screws (2) that fix it to the
rubber-pressing blade (3).
ATTENTION: The left side splash guard is depicted in the figure here, proceed in
the same way when working on the right one
49.
ADJUSTING THE HEIGHT OF THE SIDE SPLASH GUARDS
If the side splash guard rubbers on the brush head are not positioned correctly in relation to the floor, these
may not function properly (i.e. they may not conduct water to the squeegee correctly). The height of the
splash guard rubbers must therefore be adjusted. This operation can be done with the brush head body in
the work position, proceeding as follows:
1.
Check that the parking brake is engaged, and if not, engage it
2.
Check that the electrical system connector is disconnected from the battery connector, and if not,
disconnect it
3.
Check the main switch is on “0” (turn it to this position if necessary)
4.
Turn the knobs (1) on the brush head body in a clockwise or anticlockwise direction
ATTENTION: When the knobs (1) are rotated in a clockwise direction, the side
splash guards move away from the floor, while if the knobs (1) are rotated in a
anticlockwise direction, the side splash guards move towards the floor.
5.
Check that the rear splash guard rubber (2) is resting uniformly on the floor
During working operation, the side splash guard rubber is slightly tilted outwards (by about 5mm) in a
uniform way for its whole length.
50.
CLEANING THE DETERGENT SOLUTION SUPPLY PIPE
If the detergent solution supply pipe on the brush head unit is obstructed by dirt, it will not distribute the
detergent solution uniformly on the floor. This will prevent the machine from functioning properly. To clean
the basin proceed as follows:
1.
Check that the brush head body is in the work position, otherwise turn the I-DRIVE selector to the
"Scrubbing" position so that the brush head lowers
2.
Ensure that the electrical system connector is disconnected from the battery connector
3.
Make sure that the main switch is in the "0" position, if not turn the key a quarter turn to the left
4.
Check that the parking brake is engaged, otherwise engage it using the pedal (1).
3
4
2
1
1
2
1
Summary of Contents for SMG130 S
Page 1: ...USE AND MAINTENANCE MANUAL SMG130 S ED 09 2019 ENG ORIGINAL INSTRUCTIONS Doc 10033803 Ver AB...
Page 45: ......
Page 46: ......
Page 47: ......
