Page 11
Boomless “Wet” Boom Assembly
Exploded View/Parts List
(5275260)
End Nozzle Assembly
5275122
Center Nozzle Assembly
5275123
Multi-Lid Directions
1. Open fill cap and place garden hose into tank. Fill tank to desired gallon
marker, if marker is above the bottom of calibration container, stop before
water reaches calibration container. This is done to help chemical mix
better and keep foaming of chemical to a minimum later.
2. Remove Multi-Lid and use calibration container to measure the correct
amount of chemical for the water being used.
3. Pour chemical into tank and tighten Multi-Lid back onto tank. If desired
amount of water was added in step 1, you are done. Be sure to press firm-
ly on fill cap to seal with Multi-Lid. If desired amount of water was not met
in step 1, proceed to step 4.
4. Open fill cap and place garden hose into tank. Add water to the desired
gallon marker. Close fill cap, pressing firmly to seal cap to Multi-Lid.
NOTE: If water and chemical has not mixed properly, use the pressure adjust-
ment control on the manifold to recirculate the mixture through tank.