Page 5
Step 5
Step 6
Assembly Procedure (LG-3025-PRO)
*** The Sprayer should now be ready for use ***
After your boom is attached, locate the 48” hose and
the (2) hose clamps from the parts bag.
Place the hose clamps over each end of the hose
loosely. Slip the ends of the hose over the hose barbs
on both the manifold and on the center nozzle. Use a
twisting motion, if necessary, to get the hose fully onto
each barb. Bring the hose clamps to the connection
point and tighten securely.
NOTE:
Make sure this boom feeder hose does not end up on
the ‘outside’ of the spray wand hose, otherwise
unwrapping the spray wand hose from around the tank
may be difficult.
Detail A: Install the pressure gauge. Hand tighten
securely.
** DO NOT OVER-TIGHTEN **
Detail B: Screw the lid onto the tank.
Detail C: Locate the handgun bracket, grommet and
screw from the parts bag and install onto
the tank.
A phillips head screwdriver is required for this step
Place the grommet in the bracket and then place a
screw through the hole in the bracket and bring it up to
the tank, where the embossment for the bracket is
located (on the front side of the tank)
Secure to the tank. Tighten so that the bracket is
secure.
** DO NOT OVER-TIGHTEN **
The spray wand will slip into the bracket once installed.
DETAIL B
DETAIL C
DETAIL A
5167031
1/4” FPT
Manifold
5038916
5117167
Detail C
Detail B
Detail A
5075014
