Page 1
General Information
Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your Skid
Sprayer.
www.fimcoindustries.com
1000 FIMCO Lane, P.O. Box 1700, North Sioux City, SD 57049
Toll Free Phone: 800-831-0027 : Toll Free Fax: 800-494-0440
[5008116
(12/18)]
Model: LSS-235-H (5301869)
(200 Gallon Lawn Service Skid Sprayer w/160cc Honda Engine)
Technical Specifications
200 Gallon Polyethylene Tank
160cc Honda Engine, Recoil Start
3 Diaphragm Pump
Maximum Flow = 10.6 GPM
Maximum Pressure = 580 PSI
Maximum Temperature = 140°F
GunJet Spray Gun w/1/2” x 300’ of Hose
Delta Jet Agitator
Caution: When fully filled with water, this sprayer will
weigh approx. 2,065 lbs..
Consult the owner’s manual for your vehicle to verify
that you are within it’s load carrying capacity.
Retain a copy of your receipt for your unit,
as it will be required to validate any warranty service
Products are warranted against manufacturer or workmanship
defects for one year from date of purchase for home owner
usage and 90 days for commercial usage.
For technical assistance, visit our website @
www.fimcoindustries.com or call:
TOLL FREE @ 1-800-831-0027
Our Technical Support Representatives will be happy to help you.
To obtain prompt, efficient service, always remember to give the
following information…
Correct Part Description and/or part number
Model #/Serial # of your sprayer
Part descriptions and numbers can be obtained from the illustrated
parts list section(s) of this manual.
OWNER’S MANUAL
Before Operating the Sprayer
1. Add proper oil to the engine crankcase and gasoline to
the gas tank. Always check the oil in the gear box. Refer
to engine manual for correct oil type. Add SAE 30 to the
sight level in the diaphragm pump. Fill the gear case with
90W gear lube until the gear lube runs out the side plug
hole.
2. Add plain water to the tank and check the system for
leaks. Open the suction line valve. Open the lever valves
by the pressure regulator that are connected to the hand-
gun line and jet agitator line.
3. The pumping system includes an agitator, which will help
keep the solution in suspension. Pressure to the agitator
should never exceed 100 PSI. When spraying at pres-
sures over 100 PSI, use the valve (in the agitator line) to
throttle the pressure to the agitator by closing the valve.
The valve may be opened slowly until the gauge reaches
100 PSI.
Do not exceed recommended pressure on pump or
sprayer, as it may cause hoses to burst and will shorten
pump life.
***WARNING***
This product when used can be dangerous and can cause
bodily harm, only if not properly used or guarded.
* STAY AWAY FROM EQUIPMENT
WHEN IT IS IN OPERATION *
Read information and the full instructions furnished with the
product
before installing and operating.
