8
3. LOADING THE WELDING WIRE
To load the welding wire, follow these instruc-
tions carefully, in the order described below.
Warning:
before inserting the wire, always
remove the gas nozzle (Fig. 4A) and the wire
feeder tip (Fig. 4B) from the welding torch.
1.
Disconnect the cable from the power supply
(18 of Fig. 2)
.
Caution:
before proceeding with the next step, make sure
the torch cable (Fig. 4) is well extended and that the wel-
ding wire does not have any bends or burrs. Failure to fol-
low these precautions could damage the wire-feeding tube
inside the torch. Once the wire has been threaded through
the torch, attach the wire-feeder tip and the gas nozzle.
N.B.
When changing the diameter of the wire, make sure
that the correct cable of the wire-feeder spool is facing
towards the inside of the machine. To do so, ensure that
the diameter and type of wire is legible (facing towards the
outside of the machine) Remember that the spools with a
‘V’ cable are suitable for feeding iron and steel wire. The
spools with a ‘U’ are suitable for aluminium wire.
Tighten or loosen the hex socket to set the cor-
rect tension: tightening too much can cause
excessive tension that could prevent the spool
from turning correctly. On the other hand, if the
tension is too loose, the welding wire could
accidentally unwind.
2.
Unscrew the
ball-grip knob in
the centre of the
spool support of
the welding wire
(
22 of Fig. 3
).
7.
Insert the wire
into the inlet tube
(26 of Fig. 3A)
of the wire fee-
der motor. .
9.
Lower the
upper spools
4.
Remove the
plastic wrap
from the new
spool and place
the spool on the
appropriate sup-
port (
22 of Fig. 3
).
5.
Please note that
the hex socket
(M8) situated in the
centre of the spool
support is part of
the wire tension
system.
3.
If necessary,
depending on
the size of the
spool used,
remove the
bearing spool.
4.
Replace the
ball-grip knob.
6.
Lower the roll
feeder (
25 of Fig.
3A
)
8.
Run the wire
under the wire
feeder spools all
the way to the
out-let of the
Euroconnector.
10.
Lift the knob
of plastic
(25 of
Fig 3A)
of the
pressure regula-
tor of the wire.
Summary of Contents for TM 236
