Place the Rubber Gaskets (A) on the rear
potions of the front and back lock bodies.
A small lip should surround the lock bodies.
The potion of the gasket that makes
contact with the door should be smooth
and flat.
Installing the BioBolt on a US Standard Preparation Door
With the gasket attached, place the front lock
body (the side with the scanner) through the
door hole. Be sure to align the tailpiece (A)
vertically through the deadbolt cross slot (E).
Only a small portion, if any, of the tailpiece
should extend through the door width (A).
Also, be sure to pass the Control Cable (B)
through the hole.
With the front lock body held against the door
with the tailpiece aligned vertically (A), verify
that the Motor Drive Coupler (D) is also
aligned vertically.
Now, connect the Control Cable (B) to the
corresponding Control Connector (C) on the
back lock body.
A
B
A
A
B
C
E
D
3
Align the front and back lock bodies so they
are straight on the door. Insert the two bolts
in the corresponding holes and try to thread
them into the front lock body.
Locate the Bolt Direction Switch (A) just under
the batteries. Make sure the Bolt Direction
Switch corresponds with the direction that the
bolt extends (B). In the example to the right,
the bolt extends out of the left side of the door.
Therefore the switch should be moved to the
left as shown by the diagram (C).
A
C
B
BioBolt X2 Biometric Deadbolt
Installation Manual
