Use on clean and completely dry skin
with no cream or cosmetic residue.
1. Remove cover (see image 1).
2. Move switch to ON position (toward head)
(see image 2).
3. Purple Sensa-Light Technology
™
and green LED
will flash (see image 3).
4. Touch the Sensa-Light
™
Head to skin to begin
hair removal process.
The unit will not
begin to work until contact has been
made with skin.
The purple Sensa-Light
Technology™ head and the green activation
LED will remain on while the unit is in use.
Hold the FT YES to skin and gently glide the
head of the unit along skin in the opposite
direction of hair growth at a 45° angle
(NOT
straight up and down)
, (see image 4).
DO NOT APPLY EXCESSIVE PRESSURE
DURING USE
to avoid damage to skin or
head of unit. Discontinue use if any skin irritation
results.
5. For short hair, hair stubble or touch-ups select
the Microfoil Head (see image 5). For best results
while using the Microfoil Head, hold the unit
straight up and down
(NOT on a 45° angle)
and apply SLIGHT pressure (see image 6).
6. FT YES will turn off within approximately 6
seconds. Green LED will return to flash. Unit
will automatically turn on again when it
comes in contact with skin.
7. When finished using your FT YES, turn switch
to OFF position (away from head), cover and
store in a cool dry place.
Image 1
Image 2
Image 6
Usage for Sensa-Light
™
Head
Usage for Microfoil Head
Image 3
Image 4
Image 5
straight
up & down
*
Charging Cable
Cleaning Brush
Finishing Touch Yes!
™
Sensa-Light
™
Head
Microfoil Head
Cap
Adapter
Contained within
the Package
*
Adapter and
Charging Cable
NOTE:
Prior to first use, fully charge FT Yes for
approximately 2.5 hours.
FT Yes must be charged with the supplied USB cable,
using either the supplied AC adapter or an alternate
USB source.
Charging the Battery
Directions for Use
straight
up & down
45°
angle
To remove the head - place your thumbs on the
back side of the head. Push gently in the direction
of the arrow (see image 7).
To attach a head - align the arrow on back of
head with the centre of the back of and unit and
push the head on to the unit (see image 8). The
head will click into position.
Replacement of Microfoil Heads
Image 7
Image 8
*
Appearance/Type of plug adapter may vary from image based on socket type.
While the unit is charging, the red light will remain on.
The green LED will remain on when unit is connected to the
adapter and fully charged. Charge will hold approximately
60 minutes run time.
FOLD
FOLD
