www.HavocAmps.com
HOT
H
AVOC
Preamplifier (Model 15236): User’s Manual 15254 Revision 0
6
the amplifier is designed to clip once the output signal reaches over 1
Vrms; this is important to avoid damage to guitar pedals and other gear
you might plug into.
7.
POWER
It turns it on when you want to rock, and turns it off when you
are finished.
REAR PANEL
8.
POWER
Plug the included IEC power cable in here, and plug the other
end into a grounded 120 VAC outlet. Be sure to use a properly
grounded outlet. Do NOT remove the ground pin from the
power cord, due to shock hazard.
9.
FUSE
The power cord receptacle contains a fuse for protection. Only
replace the fuse when the power cord has been disconnected,
and only with like specifications (see SPECIFICATIONS on page
7). If your amplifier is blowing fuses, send it in for service (see
SERVICE AND SUPPORT on page 3). Do NOT replace with a
larger current rating fuse.
8 9
10
