English
- 9 -
Aerial Connection
•
Connect the aerial TV plug to the AERIAL INPUT
socket located at the rear of the TV.
1
3
Power Connection
IMPORTANT
: The TV set is designed to operate on
220-240V AC, 50 Hz socket.
After unpacking, allow the TV set to reach the
•
ambient room temperature before you connect the
set to the mains.
Plug the power cable to the mains socket outlet.
•
Switching the TV On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC, 50
•
Hz socket.
To switch on the TV from standby mode either:
•
Press the “
•
” button,
P+
/
P-
or a numeric button
on the remote control.
Press the
•
-P/CH
or
P/CH+
touch button on the TV.
The TV will then switch on.
By either method the TV will switch on.
To Switch the TV Off
Press the “
•
” button on the remote control or press
the STANDBY touch button on the TV, so the TV will
switch to standby mode.
To power down the TV completely, unplug the
•
power cord from the mains socket.
Note: When the TV is switched to standby mode, the
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active. The LED can also blink when you switch on
the TV from standby mode.
First Time Installation
IMPORTANT: Ensure that the aerial is connected
and a Common Interface module is not inserted
before switching on the TV for the first time
installation.
Do not insert a common interface module during the
search process.
When the TV is operated for the first time, the
•
installation wizard will guide you through the
process. First, the language selection screen will
be displayed:
Use “
•
” or “ ” buttons to select your language
and press
OK
button to set selected language and
continue.
After selecting your language, you will be required
•
to make the following settings:
Country, Teletext
Language, Scan Encrypted.
By pressing “
•
” or “ ” button, select the
Country
you want to set and press “ ” button to highlight
Teletext Language
option. Use “ ” or “ ” button
to select desired
Teletext Language
.
Press “
•
” button after setting Teletext Language
option.
Scan Encrypted
will be then highlighted.
You can set
Scan Encrypted
as
Yes
if you want to
scan coded stations.
Press
•
OK
button on the remote control to continue
and the following message will be displayed on the
screen:
