English
- 20 -
Automatic Channel Scan
Automatic channel scan is started by pressing
OK
button while Automatic channel scan item is
highlighted.
The following message appears on the screen:
Highlight
Yes
or
No
by using “ ” or “ ” buttons and
press
OK
button to con
fi
rm.
If
Yes
is selected, automatic search starts.
Selecting
No
cancels automatic search.
After search is completed for digital channels, a
message asking whether to search for analogue
channels appears on the screen:
Highlight
Yes
and press
OK
button to search for
analogue channels. The following menu appears on
the screen for analogue channel search:
Set Language item by pressing “ ” or “ ” button.
Press “ ” or “ ” button to highlight Country item and
then use “ ” or “ ” to set. Press “ ” or “ ” button to
highlight TXT Language. Select a region by using “ ”
or “ ” button. When
fi
nished, press OK or RED button
to continue. To cancel, press the BLUE button.
After
APS
is
fi
nalized, the programme table will appear
on the screen. In the programme table you will see
the programme numbers and names assigned to the
programmes.
Manual Search
In Manual Search, the number of the multiplex is entered
manually and only that multiplex is searched for the
channels. For every valid channel number, signal level
and signal quality are shown on the screen.
In both manual and auto search any existing channel
in the database is not re-stored to avoid redundant
duplicates of that channel.
Frequency Search
Enter the desired frequency. When
fi
nished, press OK
button, and the TV wili start frequency search.
Clear Service List (*)
(*) This setting is visible only when the Country option is set
to Denmark, Sweden, Norway or Finland.
Use this setting to clear channels stored. Press “
” or “ ” button to select Clear Service List and then
press
OK
. The following OSD will be displayed on
the screen:
Press
OK
to cancel.
Select
Yes
by pressing “ ” or “ ” button and press
OK
to delete all of the channels.
First Time Installation
The user can use this item to load default settings,
which were loaded to the receiver at the factory.
To install factory settings, highlight “
First Time
Installation
” menu item and press
OK
button, then
you will be asked whether or not to delete the settings.
Selecting “
Yes
” by pressing
OK
button while the “
Yes
”
is highlighted, will delete the existing channel table.
After factory settings are loaded, “
First Time
Installation
” menu will be displayed.
The menu which is displayed for language selection
appears on the screen at
fi
rst. By using “ ” or “ ”
buttons, select the desired language option, and press
OK
button to activate.
After then, “First time installation” OSD will appear on
the screen. By pressing “ ” or “ ” buttons, select the
Country
you want to set and press
OK
button (* only
for EU countries).
Next, active antenna mode selection OSD will appear
on the screen. Use “ ” or “ ” to set and press
OK
to
A01-[GB]_MB36_MASQUE_HDIDTV-MPEG4_BRONZE8_42880W_5110UK_10069551_50173691.indd 20
A01-[GB]_MB36_MASQUE_HDIDTV-MPEG4_BRONZE8_42880W_5110UK_10069551_50173691.indd 20
17.08.2010 10:21:06
17.08.2010 10:21:06
Summary of Contents for 42FLHX880HU
Page 109: ...50173691 ...
