18
9.4 Programming the heating phases
1
Press the Right-hand arrow button until the LED under the "Prog." display lights up.
2
Select a program (1 - 9) using the
and
buttons.
3
Press and hold the Programmingbutton until the function display shows that it is ready for
input.
The LED flashes.
9.5 Programming phase temperatures and holding times
Entering the heating parameters for phase 1:
2
Select the temperature by pressing the Right-hand arrow button.
3
Select the temperature using the
and
buttons.
4
Select the holding time by pressing the Right-hand arrow button.
5
Select the holding time using the
and
buttons.
NOTICE
Up to nine different heating programs can be set in the program controller.
NOTICE
If a button is not pressed within 60 seconds in Programming mode,
the program controller will skip back to the previous display.
NOTICE
In programming mode, individual heating curves can be specified by
setting up to four phases.
1
Select the heating speed using the
and
buttons.
The minimum heating speed is 1 °C/min (2 °F/min),
the maximum heating speed is 25 °C/min (54 °F/min).
NOTICE
The maximum temperature is 1550 °C (2786 °F).
