19
ENG
6
Navigate to the level selection using the Right-hand arrow button.
The levels are selected using the
and
buttons.
7
Carry out steps 1 to 5 for additional phases.
9.6 Saving the heating program
After programming the specific heating parameters for a phase, you can exit programming mode.
1
To exit programming mode, press and hold the Program button until the LED under the
function display lights up permanently.
The program has been permanently saved.
9.7 Starting a heating program automatically
The sintering oven can be programmed via an integrated timer so that it finishes the heating program
currently loaded at a specific finishing time. The integrated timer is used to specify the day and time at which
a program should finish.
1
Select a program.
2
Activate the timer by pressing both of the Arrow buttons.
The “weekday" LED (item A) lights up.
NOTICE
The maximum holding time is 999 minutes.
If a longer holding time is required, another phase must be added.
